
How-to guide
How to clean a jute rug
Clean a jute rug the dry way: vacuum it weekly, blot spills straight away and dry any damp spot fast. Too much water can brown it, shrink it or let mould grow.
The short answer
Keep water to a minimum. Vacuum weekly with the beater bar off. For a spill, lift any solids and blot from the edges in with a clean white cloth, without rubbing. Test equal parts white vinegar and warm water on a hidden spot, then dab it on with a cloth wrung out until just damp. Dry it fast with a fan or a hairdryer on cool. Never steam clean or soak jute.
What you need
- Vacuum, beater bar off
- White cloths and paper towel
- White vinegar
- Mild dish soap
- Baking soda
- Hairdryer or fan
How to clean a jute rug, step by step
Vacuum every week. For a spill, start at the second step.
- Vacuum weekly with the beater bar offUse suction only or turn the brush roll off, as a beater bar can fray the fibres and pull at the binding. Go over it in several directions, gently at the edges. Dirt left in the weave can turn a small spill into a big mark.
- Lift solids and let mud dry firstScrape up anything solid with a spoon or a blunt knife, working from the outside of the spill towards the middle. Let mud dry completely, then scrape it away with a blunt edge and vacuum.
- Blot the spill at once, without rubbingAct fast. Press a clean white cloth or paper towel onto the spill and lift, working from the edges in. Rubbing spreads the spill, pushes it deeper and frays the fibres.
- Test your mix on a hidden spotMix equal parts white vinegar and warm water, or a little mild dish soap in water for food and drink. For red wine, use soda water. Test the mix on a hidden spot first.
- Dab it on with a damp clothWet a clean white cloth in the mix and wring it out until it is just damp. Dab the stain gently, working in from the edges. Dampen the cloth, not the rug, and never pour liquid onto jute.
- Dry the spot fast with cool airPress a dry towel on the spot to soak up what you can, then dry it with a fan or a hairdryer on cool. If the spill went through, lift or prop the rug so air gets underneath. Damp jute left sitting is where brown marks and mildew start.
- Use baking soda for smells, then vacuumSprinkle baking soda over the spot to soak up any smell, and leave it for a few hours or overnight. Then vacuum it up, with suction only, as in the first step.
What you need to clean a jute rug
Have these ready before a spill happens.
Vacuum, beater bar off
A vacuum with a suction-only setting, or a brush roll you can turn off. A beater bar can fray jute and pull at the binding.
White cloths and paper towel
Clean white cloths or towels and paper towel, for blotting spills and soaking up water. Keep a few dry ones for the drying step.
White vinegar
Mix it with an equal amount of warm water to dab on food and drink spills and everyday marks. Test the mix on a hidden spot first.
Mild dish soap
A mild dish soap or detergent with no bleach in it, diluted in water, is the other usual mix for food and drink spills.
Baking soda
Plain baking soda, sprinkled on dry and vacuumed up later, soaks up smells without putting more water into the rug.
Hairdryer or fan
A hairdryer with a cool setting, a fan, or both, to dry a damp spot quickly. Heat can make jute fibres brittle.
If your jute rug has mould on it
From government pages about mould in the home, not about jute rugs. Read them if a damp rug has grown mould.
Mouldy soft furnishings need a professional
On its page about mould removal at home, the Better Health Channel says contaminated soft furnishings that cannot be put in a washing machine will have to be cleaned professionally. If this is not possible, it says they may need to be thrown out.
Who should keep away from mould
The same page says some people should not remove mould or be present when it is removed, including pregnant women, children and people with weakened immune systems or chronic lung diseases. If you decide to remove mould, it says to make sure there is good ventilation and wear protective clothing, including rubber gloves, eye protection and a P1 or P2 face mask.
Do not dry brush mould
The Better Health Channel also says not to dry brush a mouldy area, as the brush can flick spores into the air where they may be breathed in. If you vacuum mould-affected areas, it says to use only a vacuum with a HEPA (high efficiency particulate air) filter.
What not to do to a jute rug
Jute guides warn against each of these.
| Do not | Why |
|---|---|
| Steam clean it | Heat can set browning, and the moisture can shrink the rug, leave water marks or stop it lying flat. |
| Soak, hose, pressure wash or machine wash it | Jute soaks up water like a sponge. Too much can leave brown marks and tide lines, shrink it, weaken the fibres and let mould grow. |
| Use bleach or carpet shampoo | Harsh products made for synthetic carpet can break down natural fibres. A bleach-like product can leave a pale patch on light jute that cannot be undone. |
Checked on 12 November 2026.
Where jute guides disagree
Each side carries a risk to the rug, so here is what each says.
Drying in the sun
Two guides dry jute in direct sun. Two others say sun can break down the fibres, scorch and fade jute, and not to hang it wet, as the weight of the water can stretch it. The Western Australian Museum, writing about textiles in collections, says all forms of light are damaging to textiles.
Water rings and brown marks
One guide lightly mists the whole rug with clean water, feathers out the mark with a damp white towel and dries it evenly with a fan, but only when necessary. Another says a brown ring is usually the fibre itself discolouring, so more water tends to spread it, and an old ring is worth having looked at first.
Enzyme cleaners for pet urine
General rug advice is that urine usually needs an enzyme treatment and a thorough wash. Two jute guides warn against enzyme cleaners unless the label says they are safe for natural fibres like jute, as some rug makers advise against them. Either way, blot urine straight away and keep the spot as dry as possible.
When to call a professional
Call a professional if any of these apply.
- A stain is old or will not shiftOld or deep-set stains, and any that blotting has not shifted, are best left to a rug cleaner who specialises in natural fibres. Results depend on the stain and how long it has been there.
- A smell has set in or keeps returningA pet smell that keeps coming back, widespread pet accidents or a musty smell need more than a spot clean. A musty smell usually means moisture is trapped in the fibres.
- The whole rug looks dullWhen the whole rug looks dull or grey, it needs a deeper clean than a spot treatment. Deep cleaning is best left to a professional, to avoid damaging the fibres.
- Brown marks or water rings appearSome brown marks are the fibre itself changing colour and may not come out. Browning from slow drying can often be improved, but marks from the fibre's natural oils are harder, so have it inspected first.
A professional typically checks the fibre first, then uses a low-moisture method: dry soil removal, careful spot treatment and fast, controlled drying. Ask how they will clean it: a standard hot water extraction with no mention of the fibre is a warning sign. As an estimate, a natural-fibre rug of about 2 by 3 metres typically costs $60 to $350. Home Ready Cleaning passes your job to one local cleaning business.
Full details: Rug cleaning
More on rug cleaning
More how-to guides
Rug cleaning in the most searched places
About Home Ready Cleaning
Official sources
Checked on 13 November 2026.
- Better Health Channel, Mould removal at home
- Western Australian Museum, Conservation and Care of Collections (2017), Textiles chapter
