Get my home cleaned
A carpet cleaner using a steam cleaning wand on a beige carpet in an Australian living room

Stain and smell guide

How to spot clean carpet

Spot clean a carpet stain, fresh or old, with white cloths, water and a mild detergent mix. What matters most is to start straight away and blot, never rub.

Updated 13 November 2026. Health and safety points come from four government sources, listed at the end.

The short answer

Start straight away. Lift off any solids, then blot with a clean white cloth from the outside in, never rubbing. Dab on a little cold water and blot. Test a mild dishwashing liquid mix on a hidden spot, dab it on, leave it 3 to 5 minutes and blot. Rinse with plain water and blot, repeat while it keeps improving, then press it dry under a weighted towel.

What you need

  • Clean white cloths
  • Mild dishwashing liquid
  • Cold water, spray bottle
  • Thick towel and a weight
  • Shop stain remover, optional
Step by step

How to spot clean carpet, step by step

For a fresh spill. For an old stain, start with the old stain steps further down.

  1. Lift off solids, or vacuum a dry messStart straight away, before the spill soaks into the fibres and the underlay. Scoop up anything solid with a spoon or blunt knife, from the outside edge towards the centre. If the mess has dried, vacuum it first.
  2. Blot from the outside in, never rubPress a clean white cloth straight down and lift, working from the edge towards the middle so the mark does not spread. Do not rub or scrub: it pushes the stain deeper and frays the fibres into a fuzzy patch.
  3. Dab on a little cold water, then blotDampen the spot with a little cold water and blot again. Start cold even if you do not know what the spill was: hot water sets blood, milk, egg, vomit and urine into the fibre.
  4. Mix a mild detergent and test itStir a quarter to half a teaspoon of mild dishwashing liquid into a cup of cool or lukewarm water. Test it on a hidden patch, such as inside a wardrobe, and check the cloth for colour. If colour comes off, stop. Never use bleach: it leaves a permanent pale patch.
  5. Dab it on, wait, then blotDab a little of the mix onto the stain with a cloth, from the edges in. Leave it 3 to 5 minutes, then blot. Several light rounds work better than one soaking.
  6. Rinse with plain water and blotDab on clean water and blot until the spot no longer feels soapy. Leftover detergent stays sticky and catches dirt, so the patch turns grey and looks as if the stain has come back.
  7. Repeat, then press it dryRepeat the rounds while each one lifts more. Then lay a thick towel on the spot with a flat weight on top, overnight if needed, and let it dry fully before anyone walks on it. If the mark creeps back as it dries, treat it again.
What you need

What you need to spot clean carpet

Have these ready before you start.

Clean white cloths

Plenty of white cloths or white paper towel to blot with. A coloured cloth can bleed its dye into the carpet.

Mild dishwashing liquid

The base of the cleaning mix. On wool, use a wool-safe detergent instead, as wool takes a narrower range of products than synthetic carpet.

Cold water, spray bottle

Cold water for the first rinse, and for blood, milk, vomit or urine, with a spray bottle to mist it on.

Thick towel and a weight

A thick white towel or layers of paper towel, under a flat weight, draws the last of the moisture out of the backing as the spot dries.

Shop stain remover, optional

An alternative to the home mix. Read the label, as some removers do not suit all carpets, and on a wool carpet use one that is marked wool-safe.

Health and safety

Using cleaning products safely

Each point as an Australian government body puts it.

Better Health Channel

Read the label and air the room

The Better Health Channel says to read the label before you use a product and follow the instructions, to have the recommended protective equipment, such as gloves, safety goggles and a face mask, and to work in a well ventilated area. It warns that chemicals may create a poisonous gas or liquid when mixed.

SA Health

Keep children and pets away

SA Health counts cleaning products, including dishwashing liquid and bleach, among household poisons. It says to keep children, pets and toys away from where you are using them, and if you think someone has been poisoned, to call the Poisons Information Centre on 13 11 26.

Eurobodalla Council

Solvents can catch fire

Eurobodalla Council in NSW counts spot removers and rubbing alcohol among household solvents, and says most solvents are flammable. It says to work in a well ventilated area away from children and pets, and away from sparks, heat and flames.

By stain

How to spot clean different carpet stains

The steps above suit most spills. These stains need something different.

StainWhat to do differently
Coffee, tea, red wine or juiceBlot fast, then add about a tablespoon of white vinegar for every two cups of the detergent mix. On wool, see the vinegar note below.
Blood, milk, egg, vomit or urineCold water only, never hot, as heat sets these stains. For urine, use an enzyme cleaner, left on as long as its label says.
Oil or greaseScrape off what you can. Sprinkle on bicarb soda or cornstarch for 15 to 30 minutes, vacuum it up, then use the detergent mix.
InkDab with a white cloth moistened with isopropyl (rubbing) alcohol, from the outside in, without scrubbing. Rinse lightly and blot dry.
Cordial, food colouring or dyeOften permanent. Blot and test gently, then stop and leave the rest to a professional.

Checked on 12 November 2026.

Old stains

How to get old stains out of carpet

A dried stain takes more effort, and sometimes a stronger product, than a fresh spill.

Re-wet it and give it time

Re-wet the stain with your cleaning mix and leave it 5 to 10 minutes to soften before you start blotting. Then rinse, blot and press it dry as in the steps above.

Match the mix to the stain

Choose the mix by what the stain was: an enzyme cleaner for old pet urine, vomit or blood, white vinegar and water for coffee, tea or wine, and dishwashing liquid for grease. Repeat while it keeps lifting.

What may not come out

Some old stains, dye damage and wear will not fully clear. If the dye has lifted or the fibres are worn, no product brings the colour back: a pale patch needs a dye repair, not more cleaning.

Where guides differ

Where carpet stain guides disagree

Guides differ on these products. Here is each side, with its caution.

White vinegar on wool

Most guides use white vinegar, and one uses a vinegar and water mix on every carpet, wool included. One says to skip vinegar-heavy mixes on wool and use a wool-safe detergent, and others say vinegar is not suitable for wool or can damage its fibres.

Better Health Channel

Peroxide and ammonia

For old stains, some guides use 3% hydrogen peroxide, but only on light or synthetic carpet and never on wool. Two use household ammonia, while others avoid it on carpet or on wool, and one says its smell can lead pets to urinate there. The Better Health Channel says not to mix bleach with ammonia, acids or other cleaners, as this can release hazardous chlorine or chloramine fumes.

Official sources

Checked on 13 November 2026.

  1. Better Health Channel, Chemicals in the home
  2. SA Health, Poisoning prevention in the home
  3. Eurobodalla Council, Solvents disposal
  4. Better Health Channel, Mould removal at home

Get a carpet cleaning quote