Get my home cleaned
A carpet cleaner using a steam cleaning wand on a beige carpet in an Australian living room

Stain and smell guide

How to get oil off carpet

Get cooking oil and grease out of carpet with paper towel, baking soda or cornflour and dishwashing liquid. Act fast, and soak up the oil before any water goes on.

Updated 13 November 2026. Health and safety points come from three government sources, listed at the end.

The short answer

Act fast. Scoop up thick grease, then press paper towel onto the oil from the edge in until no more comes up. Never rub, and keep water off it for now. Cover it with baking soda or cornflour, leave it, then vacuum. Dab on dishwashing liquid in lukewarm water with a white cloth, rinse with plain water, press it dry, and repeat if it comes back.

What you need

  • Paper towel
  • Baking soda or cornflour
  • Clear dishwashing liquid
  • White cloths and a towel
  • Vacuum cleaner
Step by step

How to get oil and grease out of carpet

For cooking oil and grease. For motor oil, see the motor oil section too.

  1. Scoop and blot up the oilScoop up any thick or solid grease with a spoon. Then press paper towel onto the oil from the outside edge in, switching to a clean piece as it soaks up oil, until no more comes up. Never rub, and keep water off it for now, as both push oil deeper.
  2. Cover it with baking soda or cornflourShake a thick layer over the whole stain and a little past the edges, so it draws oil out of the fibres before any liquid goes on. Leave it 15 minutes to an hour, longer for a heavy spill, and overnight for a large one.
  3. Vacuum up the powderVacuum the powder up, going over the spot a few times. If the patch still looks dark or feels greasy, put down fresh powder and repeat. A big spill can take two or three rounds.
  4. Test the soap mix, then dab it onStir a teaspoon of clear dishwashing liquid into one or two cups of lukewarm water. Test it on a hidden spot for 10 minutes, and skip it if the colour or texture changes. Dab it on with a white cloth from the outside in, then blot. Never pour it on, as soaking the carpet can lead to mildew.
  5. Rinse out the soap and press it dryBlot with a cloth dampened in plain water to lift out the soap, which would otherwise attract dirt. Press a dry towel on the spot, standing on it if you like, until it is only slightly damp. Open a window or run a fan, and keep off it until it is dry.
  6. Check it again once it is dryOil left in the backing or underlay can wick back up as the carpet dries, or show again days later. If a dark patch comes back, repeat the powder and soap steps. Gentle repeat rounds work better than scrubbing harder.
What you need

What you need to get oil off carpet

Get these together before you start.

Paper towel

Plenty of paper towel, or a clean dry cloth, to blot up the oil. Switch to a fresh piece each time one soaks up oil.

Baking soda or cornflour

Baking soda (bicarbonate of soda) or cornflour to cover the stain. The powder soaks up oil from the fibres before any liquid touches the carpet.

Clear dishwashing liquid

A clear or plain dishwashing liquid, ideally one made to cut grease. It breaks down the oil the powder leaves behind.

White cloths and a towel

Clean white cloths to dab on the soap mix and rinse, and a dry towel to press the spot dry. Coloured cloths can transfer dye onto the carpet.

Vacuum cleaner

A vacuum cleaner to lift the powder out of the pile once it has soaked up the oil. Go over the spot a few times.

Health and safety

Oily rags, solvents and household poisons

Each point as a government or council page puts it.

SA Metropolitan Fire Service

Oily rags can catch fire

The Metropolitan Fire Service in South Australia says rags and waste with oil residues may catch fire by spontaneous combustion, and names peanut, corn and safflower oil among oils that may self-heat. It says heat builds up when the material is bunched up or in a pile, and that such material should be stored in a sealed metal container, such as a rubbish bin.

SA Metropolitan Fire Service

Washing towels with cooking oil

In a passage about commercial laundries, the same fact sheet says cooking oil left in towels after washing may self-heat in the dryer. It says to wash them in hot water with plenty of detergent, then use the dryer's cooling cycle or spread them in single layers to cool completely before folding.

Eurobodalla Council

Using solvents and rubbing alcohol

Eurobodalla Council in New South Wales says solvents, including rubbing alcohol and spot removers, are used to remove grease stains, and most are flammable. It says to work in a well ventilated area away from children, pets, sparks, heat and flames, avoid breathing the fumes, and wear protective clothing if the label suggests it.

SA Health

Keep children and pets away

SA Health counts cleaning products, including dishwashing liquid, among household poisons, and says children under five are at the highest risk. Keep children, pets and toys away from where you are using them, it says. If you think someone has been poisoned, call the Poisons Information Centre on 13 11 26.

Motor oil

How to get motor oil out of carpet

Motor oil and garage grease are thicker and darker than cooking oil. Blot and absorb them first, as above.

Soap or a solvent: guides differ

Four guides say motor oil needs a solvent, such as rubbing alcohol or a solvent spot remover made for grease, as soap and water do not shift it like cooking oil. Two use the same steps for both, and one says motor oil takes patience and repeated treatments.

If you use a solvent or rubbing alcohol

Put it on a white cloth, never straight onto the carpet, and blot. Test it on a hidden spot first and follow the label. Use it sparingly, as too much solvent can damage the carpet backing. Then blot with the soap mix to lift the residue, and rinse.

Old stains and carpet types

Old oil stains, wool and polypropylene

What changes from the steps above.

Stain or carpetWhat changes
Old or set-in stainLeave the powder on longer, up to overnight, and expect two or three rounds. Grease set for more than a few days often needs professional cleaning, and some old marks may not fully lift.
WoolWool takes a narrower range of products than synthetic carpet. Use gentle solutions and blot gently, keep bleach and hot water off it, and test on a hidden spot first.
PolypropyleneGuides differ. One says it does not absorb oil the way natural fibres do. Another says it holds on to oil and needs a longer absorbent step.

Checked on 12 November 2026.

Hot water and bleach

Hot water and bleach on oil stains

Guides split on water temperature and agree on bleach.

Hot or lukewarm water

Five guides mix the soap with warm water, and one with cold or lukewarm only. Two use hot water, but three warn against hot water or heat, and two of those say heat sets the stain.

Bleach and harsh chemicals

Keep bleach and harsh chemicals off oil stains. They can damage carpet fibres or take the colour out, and bleach can destroy wool.

Official sources

Checked on 13 November 2026.

  1. Metropolitan Fire Service (South Australia), Self-Heating and Spontaneous Combustion
  2. Eurobodalla Council, Solvents disposal
  3. SA Health, Poisoning prevention in the home

Get a carpet cleaning quote