Get my home cleaned
A clean grey tiled bathroom with a frameless glass shower screen and a timber vanity

How-to guide

Bathroom tile cleaning

Clean bathroom and shower tiles and grout yourself, from soap scum to mould spots. Check your tile type first: acids such as vinegar can damage natural stone.

Updated 13 November 2026. Health and safety points come from two government sources, listed at the end.

The short answer

Check your tile type, and keep vinegar and other acids off natural stone. Clear the room, open a window or run the exhaust fan, and wear gloves. Sweep the floor, spray on a tile or bathroom cleaner and give it a few minutes. Scrub, using a toothbrush on the grout lines. Rinse with clean water, then dry the tiles well.

What you need

  • Tile or bathroom cleaner
  • Baking soda
  • Brushes and a sponge
  • Microfibre cloths
  • Squeegee and towel
  • Rubber or utility gloves
Step by step

How to clean bathroom and shower tiles, step by step

The same method works for the floor, the walls and the shower.

  1. Check what your tiles are made ofCeramic and porcelain handle most bathroom tile cleaners. Natural stone, such as marble, travertine or limestone, needs a pH-neutral, stone-safe cleaner, as vinegar, lemon juice and other acids can etch it and leave dull patches.
  2. Clear the room, air it and sweepTake out bath mats, bottles and anything loose. Open a window or turn on the exhaust fan, and put on utility gloves. Sweep or vacuum loose hair, dust and grit off the floor.
  3. Put on the cleaner and let it workSpray on a tile, grout or bathroom cleaner, using the amount the label gives. Spread a thick paste of baking soda and water on hard stains and grubby grout lines. Leave it a few minutes on tiles, and 5 to 10 minutes on grout or paste.
  4. Scrub the tiles and the grout linesWork one section at a time. Scrub the tiles in circles with a soft brush or non-scratch sponge, without pressing hard, as abrasive pads and hard scrubbing can scratch glossy tiles. Run an old toothbrush or grout brush along the grout lines and into the corners.
  5. Rinse off all the cleanerRinse the shower walls with warm water from the hand shower, and mop the floor with clean water. Wipe other wall tiles with a damp microfibre cloth. Cleaner left on can dry into streaks. Repeat on any patch that is still dirty.
  6. Dry the tiles and air the roomDry the shower walls and glass with a squeegee, the tiles with a microfibre cloth and the floor with a towel or mop. Keep the window open or the fan on until it is all dry, as tiles left wet can bring back mould and streaks.
What you need

What you need to clean bathroom tiles

Have these ready before you start.

Tile or bathroom cleaner

A tile, grout or bathroom cleaner that suits your tile, or a pH-neutral, stone-safe cleaner for natural stone. Check the label for which surfaces it suits.

Baking soda

Mixed with a little water into a thick paste, it goes on hard stains and grubby grout lines before you scrub.

Brushes and a sponge

A scrubbing brush for the floor, a non-scratch sponge for the walls, and an old toothbrush or grout brush for the grout lines. Skip abrasive pads, which can scratch.

Microfibre cloths

To wipe the walls and dry the tiles. On mould, rinse the cloth often in a separate container of clean water so the mould does not spread.

Squeegee and towel

A squeegee for the shower walls and glass, and a towel or mop for the floor, to dry everything after rinsing.

Rubber or utility gloves

Gloves for the whole job, as the National Health and Medical Research Council advises when cleaning, with eye protection when you handle bleach.

Health and safety

Staying safe with bathroom cleaners and mould

Each point as a government health body puts it.

Better Health Channel

Never mix bleach with other cleaners

The Victorian Department of Health's Better Health Channel, on its page about mould removal at home, says not to mix bleach with ammonia, acids or other cleaners, as this can release hazardous chlorine or chloramine fumes.

NHMRC

Handling bleach

The National Health and Medical Research Council's Staying Healthy guidelines, written for childcare services, say to follow the label and dilute bleach as the maker directs, but not with hot water. They say to wear gloves and eye protection when handling it, and that bleach can cause respiratory issues and may damage some surfaces.

Better Health Channel

If you are cleaning off mould

For mould removal, the Better Health Channel says to make sure there is good ventilation and to wear protective clothing, such as rubber gloves, eye protection and a P1 or P2 face mask. It says not to dry brush mould, as the brush can flick spores into the air.

Better Health Channel

Who should not remove mould

The Better Health Channel says some people should not remove mould or be present when it is removed, including pregnant women, children and people with weakened immune systems or chronic lung diseases.

By tile and problem

Shower tiles, stone and common bathroom marks

What changes for the shower, for stone and for common marks.

Tile or problemWhat to do
Shower walls and floorThe same steps as the rest of the bathroom. Rinse with the hand shower, then squeegee the walls and glass and dry the floor.
Natural stoneA pH-neutral, stone-safe cleaner and a soft cloth, never vinegar or lemon juice. Stone usually needs sealing after a clean.
Soap scumA cleaner made for soap scum and grime, left to work, then scrubbed with a non-abrasive sponge and rinsed off.
Hard water marksGuides differ: two use vinegar and water, and one a limescale remover on non-stone tile. See below.
Mould spotsHousehold detergent is often enough, or a bathroom mould cleaner used as its label directs. If it keeps coming back, see below.

Checked on 12 November 2026.

Where guides differ

Where the guides disagree

Each side in brief, with its caution.

White vinegar

Three guides use white vinegar for light marks and hard water stains. One says it is highly acidic and can damage grout and tile glaze. The Better Health Channel says detergent or white vinegar is often enough for mould, and the NHMRC, writing for childcare services, says vinegar and bicarbonate of soda are not as effective against germs.

Chlorine bleach

One guide allows bleach on tiles with care, but not on natural stone. One keeps it as a last resort, and one says not to use it on grout. All three warn it can harm grout over time, by breaking it down, weakening it or fading it. It also wears grout sealer down faster.

Wet or dry tiles to start

Two guides loosen heavy build-up first, with about 10 minutes of steam from a hot shower behind a closed door, or warm soapy water left 5 to 10 minutes. A third wants the surface completely dry before its grout cleaner goes on. Follow your product's label.

Official sources

Checked on 13 November 2026.

  1. National Health and Medical Research Council, Staying healthy guidelines, A Healthy Environment
  2. Better Health Channel, Mould removal at home

Get a tile and grout cleaning quote